5 results (0,14200 seconds)

Show all filters

Brand

Merchant

Price (EUR)

Reset filter

Products
From
Shops

Vent Axia Sentinel Kinetic 200ZPH Horizontal Heat Recovery Unit

Vent Axia Sentinel Kinetic 200ZPH Horizontal Heat Recovery Unit

Vent Axia Sentinel Kinetic 200ZPH Horizontal Heat Recovery Unit Product Part Number Sentinel Kinetic 200ZPH Horizontal Heat Recovery Unit - 407162 Description Vent Axia Sentinel Kinetic 200ZPH is a horizontal ceiling mounted whole house heat recovery system with up to 86% heat exchange efficiency. Specifically designed for new build constructions with a high level of insulation. The Lo-Carbon Sentinel Kinetic Horizontal 200ZPH meets the latest requirements of the Building Regulations ADF and ADL for whole house system ventilation: System 4 - Continuous mechanical supply and extract with heat recovery. Vent Axia 200ZPH is suitable for house sizes of up to 140m2 Filtration This unit requires 2 x G3 filter Controllability The Lo-Carbon Sentinel Kinetic Horizontal models have two fully adjustable speeds and a purge setting (maximum airflow). Supplied with the unit is a digital controller that can be used to pre-set the speeds to any required airflow within the performance range. Boost can be achieved with almost any type of sensor or switch including momentary. Integral Humidity Sensor The integral humidity sensor increases speed in proportion to relative humidity levels, saving energy and reducing noise. The sensor also reacts to small but rapid increases in humidity, even if the normal trigger threshold is not reached. This unique feature ensures adequate ventilation, even for the smallest wet room. The night time relative humidity setback feature suppresses nuisance tripping as humidity gradually increases with falling temperature Construction Constructed of galvanised steel and is fully insulated Motors The unit has 2 x low energy, high efficiency EC/DC motors Installation The Sentinel Kinetic Horizontal models designed to be horizontally mounted under a slab, with access for servicing and maintenance from below. When mounted in an unheated area ducting must be insulated. 200 ZPH models are 200mm deep, including condensate and mounting bracket. The Condensate drain is through the 'atmosphere' end of the unit. Using the fittings supplied, the final condensate connection is made outside the unit and can be completed after installation. Electrical and control connections are also made on the outside of the unit. Accessories In addition to a choice of compatible ducting systems a full range of controls, sensors, in-line silencers, floor/wall/ceiling inlet and outlet diffusers are available to complete the installation.

GBP 1915.20
1

Nuaire - AB-WM1 MRXBOX95 Unit

Nuaire - AB-WM1 MRXBOX95 Unit

Nuaire MRXBOXAB-WM1 Opposite Handed MRXBOXAB-WM1-OH Description The Nuaire MRXBOXAB-WM1 provides a maximum flow rate of 125m3/hr suitable for a house up to 73m2 floor area with up to 2 kitchens & bathrooms(no digital controller or humidity sensor is available for this model)The Nuaire MRXBOX range has been in continual improvement and production in the UK for over 15years providing a high performance, wall-mounted MVHR unit which is specifically designed to provide areliable but simple to operate system for social housing, developments and end usersBPC Ventilation are the largest independent MVHR specialists and supply this unit with up to a 5-yearparts warranty* and lifetime technical support on our top-quality systems Filtration 2 x G4 filters are fitted to the unit that are easy and inexpensive to replace(The filters are provided with plastic covers that should be removed before starting unit for first time) CONTROL OPTIONS The Nuaire MRXBOX units are controlled by one of the following:We also advise an optional boost switch should be used local to the wet rooms 4 x adjustable switches on the front of the unit Manual control Via optional 3 speed manual switch Additional external sensors achieving on-demand ventilation Switched live signal from light/remote switches Heat Exchanger This unit has a high-quality PVC counterflow heat exchanger with up to a 86% thermal efficiency protected with high-capacity filters on each side The heat exchanger is easy to remove for maintenance and any accumulated condensation is easily dispersed via a drain at the bottom of the unit Frost Protection In the event of the intake air temperature at the unit dropping below the predetermined set point (-5°C as standard) the supply fan will reduce to minimum speed, once the temperature rises above the set point the fan will return to its commissioned speed. Frost protection will only activate after ten days of continuous run time. Summer By-Pass The Nuaire AB units have a 100% summer by-Pass If the indoor temperature Intake exceeds 25°C and the outdoor temperature is within comfort zones the summer by-pass is opened automatically to help provide a comfortable indoor temperature Orientation The Nuaire units can be right or left-handed and correct orientation should be checked before purchase Construction Manufactured of powder coated galvanised steel outer cover for durability and an inside EPP lining for quietness and efficiency Mounting The Nuaire units are wall mounted as standard and are supplied with a wall bracket    

GBP 971.28
1

Komfovent Left Hand R250F Rotary wheel lay flat horizontal floor unit

Komfovent Left Hand R250F Rotary wheel lay flat horizontal floor unit

Description Komfovent R250 F Left Hand 1156589 Komfovent R250 F Right Hand 1156591 The Komfovent Domekt R-250-F heat recovery unit is a high-quality ceiling or floor mounted rotary wheel unit suitable for new houses up to 150m2 that has advanced Wi-Fi controllability and are suitable for very cold climates of down to -30° This unit has an (A) energy rating BPC Ventilation are the largest independent MVHR specialists and supply lifetime technical support on our top-quality systems, Key features- Komfovent R250 F Interactive Wi-Fi Smart control Passive house approved C6M Digital controller* Next Generation rotary heat exchanger Suitable for home sizes up to 150m2 Airflow rate @100Pa - 250m3/h Optional direct connection to kitchen cooker hood Super Quiet with insulated construction No drain or pre-heater required Highly efficient EC fans 100% summer bypass M5 filtration ‘A’ energy rating High heat recovery efficiency of up to 86%. On demand control via optional room or duct sensor options Fireplace and holiday settings CAV -VAV-DCV airflow control Plug and play easy installation Optional Humidity control Optional F7 filtration Controllability The Domekt units feature an integrated smart control system allowing you to control your system without constant adjustments via the Komfovent Home application on your home computer or mobile device, the unit also has an additional hard wired digital remote control if required App Control Wall controller (optional) 8 preset modes. Intelligent energy saving algorithms. Automatic air quality control with optional AQ sensor. Extensive weekly schedule. External Control Ability to control via a web browser for remote monitoring and repair Integration into a smart home management system. (BMS) parameters by connecting additional sensors. Optional wall controller 0-10v and 0v connections Optional boost switch Optional humidity sensor (duct mounted)   BMS Control Implemented BACnet and Modbus protocols enable simple connection into Building Management System as a result whole buildings engineering systems can be controlled at a single access point. Construction Domekt heat recovery units are double protected from corrosion. The units are constructed of galvanised steel with a powder coated finish (RAL9003) and EPP internal casing, The airtight doors are 50mm thick  with thermal locks Motors The fan motors are low energy EC fans of A+ rating and are protected from humidity and dust as well as being equipped with long-life bearings Filtration 2 x G5 filters are fitted to the unit that are easy to replace Optional F7 to air supply Summer By-Pass The Komfovent range of units have a 100% summer by-Pass If the indoor temperature Intake exceeds 25°C and the outdoor temperature is within comfort zones the summer by-pass is opened automatically to help provide a comfortable indoor temperature Low Noise Levels With airtight, aerodynamic and sound absorbing construction with perfectly balanced fans the noise levels are ultra quiet Heat Exchanger Frost Protection There is no condensation drain and Frost protection is not required unless below - 20° Orientation The units can be right or left-handed and correct orientation should be checked before purchase Construction Manufactured of powder coated galvanised steel outer cover for durability and an inside EPP lining for quietness and efficiency

GBP 2668.14
1

Komfovent Domekt R-450-V Heat Recovery Unit

Komfovent Domekt R-450-V Heat Recovery Unit

Description Komfovent R450 Left Hand 1035807 Komfovent R450 Right Hand 1035808 The Komfovent Domekt R-450-V heat recovery unit is a high-quality vertical rotary wheel unit suitable for new houses up to 295m2 that has advanced Wi-Fi controllability and are suitable for very cold climates of down to -30° This unit has a A+ rating and is Passive House Approved BPC Ventilation are the largest independent MVHR specialists and supply lifetime technical support on our top-quality systems, Key features- Komfovent R450 V Interactive Wi-Fi Smart control Passive house approved C6M Digital controller* Next Generation rotary heat exchanger Suitable for home sizes up to 295m2 Airflow rate @100Pa - 496m3/h Optional direct connection to kitchen cooker hood Super Quiet with insulated construction No drain or pre-heater required Highly efficient EC fans 100% summer bypass M5 filtration ‘A+’ energy rating High heat recovery efficiency of up to 86%. On demand control via optional room or duct sensor options Fireplace and holiday settings CAV -VAV-DCV airflow control Plug and play easy installation Optional Humidity control Optional F7 filtration Controllability The Domekt units feature an integrated smart control system allowing you to control your system without constant adjustments via the Komfovent Home application on your home computer or mobile device, the unit also has an additional hard wired digital remote control if required App Control Wall controller (optional) 8 preset modes. Intelligent energy saving algorithms. Automatic air quality control with optional AQ sensor. Extensive weekly schedule. External Control Ability to control via a web browser for remote monitoring and repair Integration into a smart home management system. (BMS) parameters by connecting additional sensors. Optional wall controller 0-10v and 0v connections Optional boost switch Optional humidity sensor (duct mounted) BMS Control Implemented BACnet and Modbus protocols enable simple connection into Building Management System as a result whole buildings engineering systems can be controlled at a single access point. Construction Domekt heat recovery units are double protected from corrosion. The units are constructed of galvanised steel with a powder coated finish (RAL9003) and EPP internal casing, The airtight doors are 50mm thick  with thermal locks Motors The fan motors are low energy EC fans of A+ rating and are protected from humidity and dust as well as being equipped with long-life bearings Filtration 2 x G5 filters are fitted to the unit that are easy to replace Optional F7 to air supply Summer By-Pass The Komfovent range of units have a 100% summer by-Pass If the indoor temperature Intake exceeds 25°C and the outdoor temperature is within comfort zones the summer by-pass is opened automatically to help provide a comfortable indoor temperature Low Noise Levels With airtight, aerodynamic and sound absorbing construction with perfectly balanced fans the noise levels are ultra quiet Heat Exchanger Frost Protection There is no condensation drain and Frost protection is not required unless below - 20° Orientation The units can be right or left-handed and correct orientation should be checked before purchase Construction Manufactured of powder coated galvanised steel outer cover for durability and an inside EPP lining for quietness and efficiency Mounting The units are wall mounted as standard and are supplied with a wall bracket Accessories 774164415           x1 Komfovent M5 Filter - Domekt R 450 V C6 (470×240×46mm) 712201292           Komfovent SIPHON for Condensate Drain DN32 745201581        

GBP 2837.46
1

Komfovent Domekt R-300-V Left Handed Heat Recovery Unit

Komfovent Domekt R-300-V Left Handed Heat Recovery Unit

Description Komfovent R300 V Left Hand 1086594 Komfovent R300 V Right Hand 1086592 The Komfovent Domekt R-300-V heat recovery unit is a high-quality floor mounted rotary wheel unit suitable for new houses up to 185m2 that has advanced Wi-Fi controllability and are suitable for very cold climates of down to -30° This unit has an (A+) energy rating BPC Ventilation are the largest independent MVHR specialists and supply lifetime technical support on our top-quality systems, Key features- Komfovent R300 V Interactive Wi-Fi Smart control Passive house approved C6M Digital controller* Next Generation rotary heat exchanger Suitable for home sizes up to 185m2 Airflow rate @100Pa - 310m3/h Optional direct connection to kitchen cooker hood Super Quiet with insulated construction No drain or pre-heater required Highly efficient EC fans 100% summer bypass M5 filtration ‘A’ energy rating High heat recovery efficiency of up to 86%. On demand control via optional room or duct sensor options Fireplace and holiday settings CAV -VAV-DCV airflow control Plug and play easy installation Optional Humidity control Optional F7 filtration Controllability The Domekt units feature an integrated smart control system allowing you to control your system without constant adjustments via the Komfovent Home application on your home computer or mobile device, the unit also has an additional hard wired digital remote control if required App Control Wall controller (optional) 8 preset modes. Intelligent energy saving algorithms. Automatic air quality control with optional AQ sensor. Extensive weekly schedule. External Control Ability to control via a web browser for remote monitoring and repair Integration into a smart home management system. (BMS) parameters by connecting additional sensors. Optional wall controller 0-10v and 0v connections Optional boost switch Optional humidity sensor (duct mounted) BMS Control Implemented BACnet and Modbus protocols enable simple connection into Building Management System as a result whole buildings engineering systems can be controlled at a single access point. Construction Domekt heat recovery units are double protected from corrosion. The units are constructed of galvanised steel with a powder coated finish (RAL9003) and EPP internal casing, The airtight doors are 50mm thick  with thermal locks Motors The fan motors are low energy EC fans of A+ rating and are protected from humidity and dust as well as being equipped with long-life bearings Filtration 2 x G5 filters are fitted to the unit that are easy to replace Optional F7 to air supply Summer By-Pass The Komfovent range of units have a 100% summer by-Pass If the indoor temperature Intake exceeds 25°C and the outdoor temperature is within comfort zones the summer by-pass is opened automatically to help provide a comfortable indoor temperature Low Noise Levels With airtight, aerodynamic and sound absorbing construction with perfectly balanced fans the noise levels are ultra quiet Heat Exchanger Frost Protection There is no condensation drain and Frost protection is not required unless below - 20° Orientation The units can be right or left-handed and correct orientation should be checked before purchase Construction Manufactured of powder coated galvanised steel outer cover for durability and an inside EPP lining for quietness and efficiency Mounting The units are wall mounted as standard and are supplied with a wall bracket Accessories 712201292           Komfovent SIPHON for Condensate Drain DN32 745201581           Komfovent C6.1 User and installer Controller

GBP 2367.11
1