235 results (0,17689 seconds)

Show all filters

Brand

Merchant

Price (EUR)

Show all

Reset filter

Products
From
Shops

Morley LT-SEN-M-L Li-ion Tamer GEN2 Monitoring Sensor

Morley LT-SEN-M-L Li-ion Tamer GEN2 Monitoring Sensor

Morley LT-SEN-M-L Li-ion Tamer GEN2 Monitoring SensorThe Li-ion Tamer Rack Monitoring system is a device that monitors lithium-ion battery off-gas events. Off-gas events occur early in the failure mode of lithium-ion batteries and very early detection of these events allow proper mitigation steps to be taken to avoid a catastrophic thermal runaway failure.Key FeaturesExtended product lifetimeCalibration-free productHighly reliable output signalLow power consumption

GBP 657.72
1

Morley HLSPS50 5.0 Amp Power Supply Unit EN54-4

Morley HLSPS50 5.0 Amp Power Supply Unit EN54-4

Morley HLSPS50 5.0 Amp Power Supply Unit EN54-45.0 Amp PSU designed to meet the requirements of EN54-4. This range of PSUs includes all of the necessary monitoring and standby capability demanded by EN54-4. Each unit comes within the same size steel enclosure for ease of use offering 2.5A or 5A alarm capability.Key FeaturesSite selectable single or twin 24 V dc output24 hour or 72 hour standby capabilityFully monitored to EN54-4Local LEDs for fast fault-findingTop or rear cable entrySpace for up to 2 x 17Ah batteries

GBP 356.08
1

Morley HLSPS25 2.5 Amp Power Supply Unit EN54-4

Morley HLSPS25 2.5 Amp Power Supply Unit EN54-4

Morley HLSPS25 2.5 Amp Power Supply Unit EN54-42.5 Amp PSU designed to meet the requirements of EN54-4. This range of PSUs includes all of the necessary monitoring and standby capability demanded by EN54-4. Each unit comes within the same size steel enclosure for ease of use offering 2.5A or 5A alarm capability.Key FeaturesSite selectable single or twin 24 V dc output24 hour or 72 hour standby capabilityFully monitored to EN54-4Local LEDs for fast fault-findingTop or rear cable entrySpace for up to 2 x 17Ah batteries

GBP 282.37
1

Morley LT-SEN-M Monitoring Sensor

Morley LT-SEN-M Monitoring Sensor

Morley LT-SEN-M Monitoring SensorThe LT-SEN-M is a Monitoring Sensor designed for use with the Li-ion Tamer Rack Monitoring System.The Li-Ion Tamer Monitoring sensors comprise on-board detection algorithms making them acutely sensitive to lithium-ion battery off-gassing compounds. They do not require calibration are compatible with all forms of lithium-ion battery form factors and chemistries and have a lifetime comparable to a typical lithium-ion battery system. The Monitoring sensors are installed at the battery racks.The Li-ion Tamer Rack Monitoring system is a device that monitors lithium-ion battery off-gas events. Off-gas events occur early in the failure mode of lithium-ion batteries and very early detection of these events allow proper mitigation steps to be taken to avoid a catastrophic thermal runaway failure.

GBP 944.63
1

Morley LT-SEN-R Reference Sensor

Morley LT-SEN-R Reference Sensor

Morley LT-SEN-R Reference SensorThe Li-Ion Tamer Reference sensors are installed to monitor the ambient environment and air inlets to cancel common mode signals.The Li-ion Tamer Rack Monitoring system is a device that monitors lithium-ion battery off-gas events. Off-gas events occur early in the failure mode of lithium-ion batteries and very early detection of these events allow proper mitigation steps to be taken to avoid a catastrophic thermal runaway failure.

GBP 944.63
1

Morley 24v 2Amp Transformer Rectifier HLS-PSU-TR20

Morley 24v 2Amp Transformer Rectifier HLS-PSU-TR20

Morley 24v 2Amp Transformer Rectifier HLS-PSU-TR20The Transformer Rectifier TR range has been specifically designed for fire and access control applications that require remote control of the power supply output. The enhanced TR range of power supplies have been specifically designed for access control applications that require remote control of the power supply output. TR power supply units are typically used to power door retainers with a link to the fire panel in order to switch off the output to the doors upon the activation of a fire alarm.The units have an expanded range of input options which includes the detection of a normally closed contact going open to provide a fully fail safe operation mode.The three input options for remote control of the output are as followsOpening of a normally closed volt-free contactClosing of a normally open volt-free contactApplication of an external 24V dc supply such as a sounder circuitLED status indicators provide quick diagnostics showing the presence of a mains input and output fuse failure.Key FeaturesRemote control of outputChoice of switching optionsLED indicationMains transient protectionFail safe operation

GBP 79.38
1

Morley 24v 4Amp Transformer Rectifier HLS-PSU-TR40

Morley 24v 4Amp Transformer Rectifier HLS-PSU-TR40

Morley 24v 4Amp Transformer Rectifier HLS-PSU-TR40The Transformer Rectifier TR range has been specifically designed for fire and access control applications that require remote control of the power supply output. The enhanced TR range of power supplies have been specifically designed for access control applications that require remote control of the power supply output. TR power supply units are typically used to power door retainers with a link to the fire panel in order to switch off the output to the doors upon the activation of a fire alarm.The units have an expanded range of input options which includes the detection of a normally closed contact going open to provide a fully fail safe operation mode.The three input options for remote control of the output are as followsOpening of a normally closed volt-free contactClosing of a normally open volt-free contactApplication of an external 24V dc supply such as a sounder circuitLED status indicators provide quick diagnostics showing the presence of a mains input and output fuse failure.Key FeaturesRemote control of outputChoice of switching optionsLED indicationMains transient protectionFail safe operation

GBP 102.06
1

Morley HLS-RES-AAPAG-ECA Pager - Black - AA Battery - ECA

Morley HLS-RES-AAPAG-ECA Pager - Black - AA Battery - ECA

Morley HLS-RES-AAPAG-ECA Pager - Black - AA Battery - ECAResponse Pagers are lightweight comfortable to wear and come with a robust beltpocket clip.Can be used for Equalities Act notification of a site alarm with simple messaging or for Fire Marshall with full Device Address displayed on the pager.The Response Paging System offers the latest innovations in wireless paging and monitoring. Its a cost effective and flexible system that provides the ability to quickly respond to activated alarms.Key FeaturesThe paging system consists of a wall-mounted High Impact Polystyrene enclosure containing 4-watt transmitter enclosed in aluminium surroundAdheres to BS 5839 and meets Equality Act 2010 recommendationsStatus indicator LED for Power and TransmissionMonitored power outputAn optional antenna dipole installed external to equipment enclosureRS232 data port input and programming15 contact closure alarms Normally Closed Contact Monitoring output to Fire PanelAlphanumeric PagersEN54-4 Power SupplyCompliance with the requirements of BS 5839 part 1 low battery audible alarm in the event of mains failureOut of RangeNo service indication to pagersA 240-volt 3 pin plug fused spur optionSite programmable for multiple Honeywell fire panel options

GBP 360.99
1

Morley HLS-RES-AAPAG-FIRE Pager Black - AA Battery - Fire Marshall

Morley HLS-RES-AAPAG-FIRE Pager Black - AA Battery - Fire Marshall

Morley HLS-RES-AAPAG-FIRE Pager Black - AA Battery - Fire MarshallResponse Pagers are lightweight comfortable to wear and come with a robust beltpocket clip.Can be used for Equalities Act notification of a site alarm with simple messaging or for Fire Marshall with full Device Address displayed on the pager.The Response Paging System offers the latest innovations in wireless paging and monitoring. Its a cost effective and flexible system that provides the ability to quickly respond to activated alarms.Key FeaturesThe paging system consists of a wall-mounted High Impact Polystyrene enclosure containing 4-watt transmitter enclosed in aluminium surroundAdheres to BS 5839 and meets Equality Act 2010 recommendationsStatus indicator LED for Power and TransmissionMonitored power outputAn optional antenna dipole installed external to equipment enclosureRS232 data port input and programming15 contact closure alarms Normally Closed Contact Monitoring output to Fire PanelAlphanumeric PagersEN54-4 Power SupplyCompliance with the requirements of BS 5839 part 1 low battery audible alarm in the event of mains failureOut of RangeNo service indication to pagersA 240-volt 3 pin plug fused spur optionSite programmable for multiple Honeywell fire panel options

GBP 360.99
1

Conventional Deep Base with Schottky Diode - 2020DBSD

Conventional Deep Base with Schottky Diode - 2020DBSD

Conventional Deep Base with Schottky Diode - 2020DBSDThere are 4 new bases from the new range of Gent conventional fire alarm equipment2020B Standard Base adds 9.5mm to detector height2020BSD Standard Base with Schottky diode2020DB Deep Base adds 21mm to detector height2020DBSD Deep Base with Schottky diodeThe base is compatible with the following2020PT Multi-Function Detector2020P Optical Smoke Detector2020R Rate of Rise Heat Detector2020F 58 Celsius Fixed Temperature Heat Detector2020HF 70 Celsius Fixed Temperature Heat Detector

GBP 9.64
1

Conventional Standard Base with Schottky Diode - 2020BSD

Conventional Standard Base with Schottky Diode - 2020BSD

Conventional Standard Base with Schottky Diode - 2020BSDThere are 2 bases from the conventional fire alarm equipment range2020B Standard Base adds 9.5mm to detector height2020BSD Standard Base with Schottky diodeThe base is compatible with the following2020PT Multi-Function Detector2020P Optical Smoke Detector2020R Rate of Rise Heat Detector2020F 58 Celsius Fixed Temperature Heat Detector2020HF 70 Celsius Fixed Temperature Heat Detector

GBP 5.64
1

Morley D2E Duct Detector Housing with B401 Base

Morley D2E Duct Detector Housing with B401 Base

Morley D2E Duct Detector Housing with B401 BaseThe InnovairFlex 2DE 2-wire photoelectric duct smoke detector features a pivoting housing that fits various applications both square and rectangular footprints mount to round or rectangular duct work. The new duct smoke detector senses airflow speeds ranging from 1.5-20m per second with proven precision. The enhancements built into this model improve false alarm immunity with plug-in sensor head broaden operation temperature -20 to 70 degree and humidity 0 to 95 percent non-condensing ranges while simplifying installation and maintenance. These advance features can detect smoke even in the harshest duct applications.The new design provides more wiring space with an added 20mm conduit knockout. Numbers and labels for terminal designations are consistent with previous Innovair models. The new sampling tube can be clicked into position with one smooth motion from either the front or the back of the detector.The InnovairFlex D2E duct smoke detector has signals to indicate trouble and maintenance conditions. Additionally a cover tamper feature is incorporated to indicate a trouble condition for removed or improperly installed sensor cover. An improved cover design with an integrated low-flow feature isolates the sensor head from low-flow technology for simple maintenance.Key FeaturesPhotoelectric integrated low-flow technologyAir velocity rating from 1.5 ms to 20.3 msecVersatile mounting options in square or rectangular configuration with modular constructionPlug-in sensorSuperb false alarm immunity with the latest sensor technologyBroader ranges for operating temperature -20C to 70C and humidity 0 to 95 non-condensingPatented sampling tube installs from front or back of the detector with no tools requiredA cover tamper feature to indicate a trouble condition for removed or improperly installed sensor coverIncreased wiring space with 15mm and 20mm conduit knockoutImproved LED status24 VDCBackward compatibility with existing DH400 range including remote accessoriesPlease Note this product does not come complete with a detector please use the 2351E.

GBP 215.50
1

Morley M210EA-CZR Analogue Addressable Monitor Module

Morley M210EA-CZR Analogue Addressable Monitor Module

Morley M210EA-CZR Analogue Addressable Monitor ModuleThis Analogue Addressable Monitor Module is designed for supervision of a conventional zone equipped with EOL resistor.The M200 wired range of Input Output modules has been redesigned to address its microcontroller obsolescence and grant full backward-compatibility with legacy systems. The M210EA-CZ and M210EA-CZR are the latest edition to this range.The EN54-17 and EN54-18 approved Wired Input Conventional Modules allow interfacing of conventional detectors to System Sensor analogue addressable systems.The conventional zone can be powered from the analogue communication line or from an external power supply. Where the conventional zone is powered from an external power supply the communication line is fully isolated from the conventional zone and from the power supply.Key FeaturesFull backward compatibilityBuilt-in short circuit isolatorsMonitors open circuit and short circuit faultsCLIP and advanced protocolAddressability through rotary switchesTri-colour light pipesRemote reset of conventional zoneZone powered from comms line or 24V PSU

GBP 114.29
1