Kennedy Single Bar Translucent Red Hot Dip
Hot dip protective plastic coating moulds around the component or tool to provide 100% coverage and protect against impact and corrosion.
Features and Benefits
Hot dip plastic coating moulds itself around the part to provide 100% coverage and protect against corrosion and impacts for up to ten years
Easy part identity through the translucent coating
Simple to remove by peeling off
Once removed, leaves behind a thin oil film to provide short term protection against corrosion
Removed coatings may be reused saving cost
Notes
Each single block measures (L)-150mm (H)-50mm (W)-80mm
Working temperature 130C to 160C (for optimum results 140C to 145C)
Warnings
Never directly apply heat to melt the protective dip
Always use with a suitable melting pot
