Fremgang.nu | Google Ads-bureau

TLWH-03 Spikes / Screws Kit for Husqvarna Automower 315/310/305

TLWH-03 Spikes / Screws Kit for Husqvarna Automower 315/310/305 - Boost Your Automower’s Grip\n\nSlip, slide and wheel-spin waste battery life and leave turf uncut. Swap your factory wheels for these cold-plated TLWH-03 spikes and your Husqvarna Automower 305, 310 or 315 gains the bite it needs on damp grass, slopes and mossy patches—no software tweaks, no extra sensors, just better traction in ten minutes.\n\nKey Features / Benefits\n- Precision cut from 2.5 mm SPCC cold-rolled steel, then electro-plated to resist rust through wet Northern-European seasons.\n- Anti-slip serrations dig into turf and mulch, reducing wheel spin and keeping cutting paths on schedule.\n- Exact OEM fit for Automower 305 (2016-), 310 and 315—no drilling or wheel modification required.\n- Includes fourteen Torx self-tapping screws; mount each ring in minutes with a T25 bit.\n- Supplied as a balanced pair, so the mower’s gyroscope and drive motors continue to run within factory tolerances.\n\nSpecifications at a Glance\n- Material: SPCC steel, electro-plated finish\n- Each spike ring: Ø 215 mm × 2.5 mm thickness\n- Fasteners: 14 × Torx head self-tapping screws (included)\n- Compatibility: Husqvarna Automower 305 (2016), 310, 315\n\nIdeal Examples of Use\n- Cut a north-facing lawn that stays dewy until mid-morning; the spikes claw through moisture instead of skimming over it.\n- Tackle a 25 \% incline behind the house—no need to pre-trim with a petrol mower.\n- Keep robotic mowing schedules on track after spring aeration, when loose soil would normally cause slip errors.\n- Maintain an orchard floor littered with wet leaves; the enhanced grip stops wheel polish and keeps blade RPM consistent.\n- Leave the mower to edge a gravel path: the spikes add just enough purchase to prevent sideways drift.\n\nWhy These Spikes Are Worth the Upgrade\nTraction problems cost time, battery cycles and blade wear. For the price of a tank of fuel in a conventional mower, TLWH-03 spikes deliver a season-long improvement in cut quality and reduce manual rescue missions. No firmware flashes, no warranty worries—just bolt on and mow.\n\nInteresting Facts About Robotic-Mower Traction\nHusqvarna’s wheel torque peaks at roughly 23 N cm. On damp grass the contact patch can slip at loads as low as 9 N cm, forcing the automower to slow or reverse. Steel spikes raise the friction coefficient by up to 0.35—enough headroom for steeper slopes and heavier spring growth without altering drive calibration.\n\nKeep your Automower working while you relax—fit TLWH-03 spikes and watch it climb, cut and coast with confidence.\n\nCompatibility: Husqvarna Automower 315, Husqvarna Automower 310, Husqvarna Automower 305\n\nPackage: Bulk

EUR 46.00

1