5 resultater (0,20173 sekunder)

Vis alle filtre

Mærke

Butik

Pris (EUR)

Nulstil filter

Produkter
Fra
Butikker

Bosch HSS-G Borebit Bor/driver

Bosch HSS-G Borebit Bor/driver

- suitable for alloyed and non-alloyed steel up to a tensile strength of 900 n/mm², cast steel, cast iron, sintered iron, malleable cast iron, non-ferrous metals, hard plastics- precision-ground hss-g drill bit enables up to 40% faster drilling rate and up to 50% lower feed pressure than standard-ground hss drill bits with a chisel edge- self-centring split point drill tip means there is no need to pre-punch or pilot drill up to 10 mm diameter- the hss-g drill bits are available in two qualities. The topline drill bits are for the highest requirements and the standard drill bits are for professional use

EUR 4.90
1

Bosch Cutting disc straight 125mm

Bosch Cutting disc straight 125mm

Are you a metalworker who needs an efficient and long-lasting disc to cut stainless steel and metal? The pro stainless steel and metal offers a good balance between lifetime and speed.with its thickness of 1.6 mm, the pro stainless steel and metal bonded cutting disc is a great choice when you need a good balance between lifetime and speed. We used premium aluminium oxide grains to ensure strength and durability. We combined the grains with functional fillers and additives to reduce heat builds-up. A high-quality fibreglass net reinforces the disc, making it safer to use. Plus, we made it iron free. This means you don’t need to worry about rust on your workpiece, if you cut stainless steel only.

EUR 3.90
1

Bosch Cutting disc Rapido straight 125mm

Bosch Cutting disc Rapido straight 125mm

Pro stainless steel and metal for long life cutting stainless steel and metallooking for a long-lasting cutting disc to cut stainless steel and metal? Try the pro stainless steel and metal. We made it with premium abrasive grains so that you can enjoy its performance for a long time.the pro stainless steel and metal bonded cutting disc uses premium aluminium oxide grains to make sure you get fast and effective cuts in stainless steel and metal. We combined the grains with functional fillers and embedded them in a phenol resin matrix for strength, resistance to heat and stable performance. We reinforced the disc with high-quality fibreglass to ensure it's safer to use. Plus, we made it iron free. This means you don’t need to worry about rust on your workpiece, if you cut stainless steel only.- appropriate for hand-held angle grinders.- maximum circumferential speed: 80 m/s (depending on rpm and disc diameter).- fe/s/cl < 0.1%.- the thin rapido disc offers many advantages: fast and clean cutting with little exertion of force, very accurate, less noise and dust, and no blue discolouration or burr formation.

EUR 3.90
1